gas fired industrial water tube hot water boiler manufacturer
Water produced by the following factors: the temperature of the flue gas (91% in order to achieve thermal efficiency, the temperature of the flue gas needed to reach 170 ℃), where the total surface area of the heat chimney, chimney and chimney material. Maintenance of the burner. Electric steam boiler and burner maintenance, repair after steam supply. Because the products of combustion will corrode the boiler, clean up carbon deposits, therefore, not allow the products of combustion in the boiler memory stay too long. 3, clean electric boiler essential content.
6 tons gas steam boiler steam pressure adjusting a boiler operation, must frequently monitor the pressure gauge indicated. To maintain stable steam pressure, boiler pressure must not exceed the design pressure. Second, increasing boiler load: Steam pressure decreased boiler load is increased, if the level is high at this time, the amount of water should be reduced to a water supply or suspend, the amount of coal and increase the air volume. Gradually increase the amount of water at the same time to strengthen the burning, keep the steam pressure and the water level is normal. Third, the boiler load reduction: the vapor pressure rises to reduce boiler load, if the level is high at this time, the amount of coal should be reduced and the air volume, reduced combustion. Then the appropriate water reduction or suspension of water supply to the water vapor pressure and stability in the nominal range. Then press the normal combustion and the amount of feed water 8 to adjust. If the actual water level within the boiler is low, to increase the amount of water should, until the water level returns to normal after the combustion and needs to be adjusted according to the water vapor pressure and load changes.
Zhengzhou Sunrise Optoelectronics Technology Co., Ltd. by the Dongxu Group, Henan Province, the state-owned asset management companies and Zhengzhou Investment Holdings Limited jointly made, mainly engaged in flat panel display and solar industry design materials, manufacturing and sales operations. Sunrise Optoelectronics project has been put into a production line, the second phase will continue the expansion, three new production lines to meet the production needs of Project Phase II, Sunrise Optoelectronics urgent need to increase new boiler equipment. After investigation and screening of a number of boiler brands, determined to cooperate with the fast boiler, steam signed a 10-ton integrated condensing gas steam boiler (WNS10-1.25-Y.Q).
Industrial boiler energy-saving technological transformation of existing problems in industrial boiler energy-saving technological transformation of Question 1, the lack of innovation, application of energy-saving boiler mature, molding technology and equipment, such as: increased flue gas heat recovery unit, blowers inverter , condensate recovery and other conventional energy-saving measures is essentially a general condition; and the need for structural changes in energy-saving measures, such as fractional bed combustion of coal and boiler furnace arch transformation techniques, etc., are rare; as transformation project new principle, a new device, oxyfuel technology, high temperature air combustion technology, spray pulverized coal combustion technology (+ supernatant layer combustion boiler combustion mode), condensing heat recovery technology, new energy technologies dust ash and water treatment equipment, is very few. In general, innovation is not enough, the technical content needs to be improved. 2, part of the boiler is not fully considered in the transformation process, but simply changing the burner, the combustion gas flow distribution and does not match the corresponding surface of the heating boiler, the boiler furnace wall insulation and sealing transformation. There is poor combustion boiler, insufficient output, higher exhaust temperature problem, can not achieve the purpose of energy saving. 3, the waste heat boiler using high temperature organic heat required for thermal processes, a boiler generally at 200 ℃ 300 ℃, the exhaust gas temperature of the boiler is usually too high, excessive. In order to meet requirements of energy saving, companies often mounted in the boiler backpass evaporator or a hot water tank, flue gas waste heat recovery, reducing the exhaust temperature. But most of the heat generated in the production process does not require little energy. 4, statistical analysis of experimental data shows that there are many problems inefficiencies run natural gas boiler. The main concern of automatic combustion control, early production debugging is not in place, and so on. Gas boiler gas and incomplete combustion abnormal increase in heat loss caused by high temperature exhaust gas is the direct cause of poor operating efficiency. However, the use of clean energy natural gas boiler, generally higher thermal efficiency, energy saving difficult. Corporate restructuring investment funds enthusiasm is not high.