Pure Steam Generator Manufacturers In Thailand
A company will supply the power island equipment, consisting of three SGT6-5000F gas turbines, one SST6-5000 steam turbine, three SGen6-1000A air-cooled generators, one hydrogen-cooled SGen6-2000H generator, three NEM DrumPlus heat recovery pure steam generator manufacturers in thailands, and a SPPA-T3000 control system. The gas turbines, steam turbine, and generators will be manufactured at the A company Charlotte Energy Hub, which is the main production facility for A company’ 60-Hz generation business.
Anyang City Minshan Nonferrous Metal Co., Ltd. is a collection of urban mining, renewable resources, energy as one of the economic wisdom of cleaning companies, mainly non-ferrous metal extraction and processing work. Company to conserve energy, cleaner production for the purpose of this concept coincides with the fast boiler. Thus, when the company in the purchase of the product boiler, and fast boiler almost hit it off, by the party to provide a fast 6 tons of steam integrally condensing gas steam boiler (WNS6-1.25.Y.Q).
Oil-fired boilers include oil-fired water boilers, oil-fired hot water boilers, oil-fired heating boilers, oil-fired bath boilers, oil-fired steam boilers and so on. Oil-fired boilers are boilers fueled by light oil (such as diesel oil, kerosene), heavy oil, residual oil or crude oil. Compared with gas-fired boiler and gas-fired boiler, oil-fired boiler runs more economically than electric heating boiler and is more convenient to use than gas-fired boiler. With the development of economy and social progress as well as the improvement of people's awareness of environmental protection, coal-fired boilers are gradually out of sight because of serious pollution. Instead, they are replaced by new types of environmental protection digital boilers, such as electric heating boilers and oil-fired boilers. Gas fired boilers, etc., electricity Heating boiler operation is the most expensive, gas-fired boiler needs to be opened with gas pipeline, then, if there is no natural gas pipeline, but also hope that the operation cost of the boiler is low, only the choice of fuel-fired boiler. Oil-fired boiler is heated by burners, fuel atomization effect is good, fuel combustion is full, chimney can not see black smoke, so fuel-fired boiler green environmental protection, efficient and energy-saving. After the fuel oil is sprayed into the furnace, it is very easy to mix with air and burn rapidly and exothermic rapidly. Compared with coal-fired boiler with the same parameters and capacity, the thermal strength of furnace volume can be doubled. However, in order to reduce the heat load in the combustor zone, the water wall tube in this zone is avoided. Because of the overtemperature, the furnace volume is only reduced by about 1 / 3. Moreover, because the ash content in fuel oil is very little, it will not be slagging on the convection heating surface, so the flue gas temperature at the furnace outlet can be as high as 1300 ℃, and the pitch between tubes on the convection heating surface can be reduced to increase the flue gas flow rate, thus the heat transfer coefficient on the heating surface can be increased. Save heating area and steel. In order to prevent spontaneous combustion of carbon black oil scale on economizers and air preheaters, steam soot blowers should be added to these parts to keep the heating surfaces clean. At the same time, because the fuel oil does not form coke slag, the membrane water-cooled wall can be used to form a micro-positive pressure (500 x 1000 cow / ml). A boiler. It can save the draft fan, only the fan can exhaust the flue gas out of the furnace. If the whole shell of the boiler is made of thick steel plate, it can also be made into a positive pressure (0.3 ~ 0.6 MPA) boiler, which can make the whole structure of the boiler more compact, and is more used in the gas-steam combined cycle generator set.
Another technology being incorporated by boiler manufacturers is the gas turbine.When a gas turbine is used, natural gas is fired, and the hot gasses are used to spin a turbine attached to an electrical generator to make electricity.Since there is still available heat in the gas that exhausts from the turbine, it is then sent through a Utility Power HRSG (Heat Recovery Steam Generator).Similar to a watertube boiler, the hot exhaust gasses from the turbine heat water in the tubes of the utility power HRSG and turn it into steam, which is then used to turn a second steam-driven turbine attached to another electrical generator.This technology is called “Combined Cycle Cogeneration”, and is a very efficient use of fuel because the same fuel source is used twice to drive turbines.