2 ton Fire Tube Gas fired Steam Boiler
Commissioning of Boiler gas boiler commissioning must be carried out after the hydrostatic test. Before commissioning, should be a comprehensive inspection of each furnace parts, electronic control devices, wiring, etc. are normal, water supply, oil furnace if opened, electrical contacts are in the set position. 1, depending on the size of the fuel consumption, the initial damper, the hydraulic pressure. 2, the power is turned on, the power switch to open the cabinet, the water pump starts furnace, (if the pump is rotated into the anhydrous, pump purge valve is opened, the air exhaust pump). 3, control checks whether the normal water level electrode. 4, check the burner operation is normal. Starter burner starts combustion when the water level rose to a predetermined level, the start of combustion is normal to observe: Start no vibration noise, stable combustion, no smoke, orange yellow flame, burning bright clear. Otherwise, to make the appropriate adjustment (refer to burner instructions). Note: The oil pressure between 0.8 ~ 1.0Mpa, after a good tune, do not easily change, oil pressure is too high or too low have an effect on burner performance life. 5, check the pressure gauge pointer swing is smooth, with or without loosening stuck. 6, whether the discharge check valve is set at the set pressure steam: Pressure controller first maximum working pressure, a safety valve is adjusted to the set pressure higher than 0.05MPa, when the furnace pressure was raised to whether the exhaust pressure setting, if exhaust , pulling the safety valve a few times, and try again, if not enough to deal with safety valve to adjust. Pressure relief valve setting: boiler rated pressure + 0.03MPa. 7, check the electrical contacts of the operation: When the pressure is raised to the maximum working pressure (not exceed the rated working pressure), should stop burning, open the safety valve blowing off steam, the pressure to a minimum operating pressure (maximum operating pressure is generally lowest set to 0.10MPa), combustion burner should be restarted. Note: When the adjustment screw should slow, especially when the pointer approaches the end, otherwise, damage the screw off the wire.
Since March this year, Haidong Qinghai province to implement the central issue environmental supervision feedback coal-fired boiler rectification work, speed up the production of green, zero emissions work processes, and improve air quality, to develop a series of coal-fired boilers on the rectification requirements of the program, as the initiative, strike out, to carry out rectification work in coal-fired boilers within the city, complete elimination of high energy consumption and serious environmental pollution of coal-fired boilers. Planned before the end of 2020, out of the new regulation since 2013 registered 10 tons of steam per hour and a total of 35 sets of coal-fired boilers. To date, 24 have been dismantled coal-fired boilers, the completion of 69% of the total demolition tasks.
In campaigns, the Haidong Market Authority established the Secretary for the head of the leading group, and achieve the "four guarantees" work. First, strengthen organizational leadership, promptly convene a special meeting arrangements, set up to director, head of the leading group, strict rectification requirements, compaction responsibility, division of labor, supervision and implementation, to ensure that the tasks, responsibilities, personnel, time to implement place; second is to strengthen the publicity and guidance, held a coordination will promote, publicize national environmental policy so that the people in charge to enhance environmental awareness, consciousness of serving the overall situation, to ensure that the main responsibility to put in place; the third is Duocuobingju full supervision of the remediation coal-fired boilers demolition work to ensure full demolition tasks to complete the rectification of high-quality, on-site in time for the use of special equipment write-off procedures to monitor and update the information platform, the rectification work will not stay dead; fourth is to strengthen the rectification pin number system and standardize accounting, according to " Qinghai province to implement the central requirements of environmental protection inspectors feedback pin number rectification work approach ", the timely development of ledger collect relevant information, to ensure that the sales numbers for the record rectification work tasks.
Up to now, the central feedback requirements Haidong included the removal of 35 planned coal-fired boilers have been demolished 24 units, of which the county mutual aid, Ledu District, safe area, Minhe County, Hualong County coal-fired boiler demolition has been completed work to complete the renovation work ahead of coal-fired boilers. Next, Haidong will continue to increase coal-fired boilers eliminated, remediation publicity work to do mass persuasion to explain, guide active community participation, active support and cooperation to carry out "ban on burning 'governance activities. Actively persuade pressure coal-fired boiler units to implement the "coal to oil", "coal to gas", phasing out coal-fired boilers high pollution, high energy consumption, encourage economic boiler unit to switch to environmentally friendly, safe and efficient biomass, natural gas, etc. clean energy.
Electric 2 ton fire tube fired steam boiler flue of accumulating a certain amount of soot how to deal with? Electric steam boiler furnace cleaning backpass long-term non-stop, accumulating a certain amount of soot or carbon black. Solution: When the temperature drops below the flue 50 ℃, check before entering the flue tail heating surface, and should completely remove the flue soot. If not burning, can be re-started ignition; if burning, should be replaced, repaired burning member; large negative pressure of the combustion chamber, so that gas will be no time to burn into the electric steam boiler tail. Solution: When the exhaust gas temperature close to the temperature of the injected steam, or less than 150 deg.] C and more stable during 1h openable inspection hole inspection, after checking element determines the source of fire, the ventilation fans before starting. When shutdown or electric steam boiler fire, air gun valve is not closed. Solution: strengthen the electric steam boiler feed water and turn on the water, open the valve or economizer recirculation tube to protect the economizer being burnt; lower start, the furnace temperature during shutdown, unburned fuel in the furnace . Solution: fire extinguishing devices immediately into steam, carbon dioxide or other fire extinguishing devices; burn improperly adjusted, with insufficient wind or with the wind unreasonable. Solution: Close the flue duct and baffle around the door opening, start sending prohibited, induced draft fan.
Gas-fired 2 ton fire tube fired steam boiler and gas steam boiler at any time there is any good compared to the country more and more attention to environmental protection, gas steam boiler has been a great blow, and relatively gas steam boiler by many users of all ages, in recent years, the country also strongly promote the use of gas-fired boiler, gas steam boiler then compared with the gas steam boiler what good is it? And today we work together to explore. Gas-fired steam boiler steam boiler and gas each accounted for half of the market, showing potential rival, but in the long run, gas steam boiler will obviously be the only dominant market. Do not believe, look! 1. Purchase costs: gas boiler is evident in the technical and auxiliary facilities are far ahead of the gas boiler, and it is equipped with a special gas burner. 1 steam boiler tonnage, for example, the price of gas than the gas boiler boiler on high about 30%. 2. Construction costs: The costs mainly from the boiler room. Because the corresponding auxiliary equipment more gas steam boiler, the boiler room in the building have a little more money. The gas boiler auxiliary facilities require little or automatic control and operation, and automatic alarm and automatic protection, not only save building costs, but also safe and reliable; Also connected to the gas pipeline, the burner will automatically supply gas can effectively save costs staff. The gas-fired boilers because of the need of coal on the program, so it needs some staff payroll. 3. Fuel cost: around this by looking at the actual specific fuel price can be clearly seen. The fact is that the amount of gas than the gas burned per hour for much more. 4. environmental costs: in the need to protect the environment, review the current gas boiler more strict. The gas steam boiler due to the operation of the economy, environmental protection and energy saving, as well as government policy to encourage more and more widely used.