water tube d type boiler supplies
Haryana power scene
1.Haryana has per capita energy consumption of 1029 units annually as against national average of about 800 units.
2. Haryana currently has total installed capacity for generation of power at 5200 MW with top power plant of CFB boilers.
3. As per the assessment study carried out by the National Productivity Council, the State has a deficit of power at 12.6 % and there is a potential of saving of 3.273 billion units of electricity annually in agriculture, commercial, Municipal, Industry & domestic sectors which is about 17% of the total annual energy sold by the Utilities.
1. When conditions water tube d type boiler supplies steam boiler before use, be sure to check the internal parts of the steam boiler, such as steam pipes and water gauge pressure gauge and the like whether it is safe in good condition, the water for steam boiler must have been after softening treatment, be sure to keep the water clean, must not contain oils job. For steam boiler safety valve must not be arbitrary regulation, to ensure the best extent possible, this does not require adjustment at any time. The exterior of the product should always be clean. 2. In the process of boosting the use of a steam boiler, be sure to check the valve is not sensitive, but need to check the height of the water level, you need to remember to keep the water level at two-thirds of the water table position, which is very important is too high or too low are not allowed, otherwise there is a risk of explosion, if steam boiler furnace has found that red-hot phenomenon, should stop using immediately for steam boilers, because in this case if continue to use the steam boiler, it is very easy to damage the steam boiler products. 3. At the same time when using steam boilers, steam boilers should always pay attention to maintaining internal and external cleaning, be sure to do maintenance work on a series of steam boilers.
Coal-fired water tube d type boiler supplies to carry out a comprehensive investigation and remediation work, Luohe City, Henan Province, Li Jizhen provincial, city and town each environmental supervision departments centralized call the relevant personnel, three-pronged approach to work.
First, a comprehensive investigation to find out the base.
Li Jizhen town for all industrial enterprises, restaurants, vermicelli processing plants, farms and other coal-fired boiler with a boiler units diagnostic investigation, the establishment of coal-fired boilers ledger, so base-clear, the situation is clear.
Second, clear standards, conducting pressure.
Town leaders organized the renovation work conference of coal-fired boilers, the boiler so that the user's overall reform and the dismantling of scheduling, the town must be eliminated in the formation of boiler upgrade, you do not need to be removed out of shutting down consensus.
Third, actively coordinate, and assign responsibilities.
Natural gas is being implemented in conjunction with the "double substitution", and actively coordinate the gas boiler equipment suppliers in collaboration with the local gas company, entered into a collaboration, timely completion of "substitution of gas for coal" upgrade tasks.
As of now, the town has shut down six coal-fired boilers, the implementation of "substitution of gas for coal" boiler upgrade eight, effectively promote the prevention and control of air pollution.
In the water tube d type boiler supplies production, daily use and installation process must be through welding treatment, then in the boiler welding problem what needs to be paid attention to? Next, we will ask the technicians of Fangkuai Boiler Factory to give us a special introduction: the boiler's furnace tube and boiler's oven box and pipe should be connected by means of welding. Only the boiler tube and the furnace box pipe welding can make it more firm. It is important to note that the heating part of the boiler should be linked by butt welding and bottomed by arc, so as to conform to the overall structure of the boiler. When welding parts of the boiler's edges and corners, it should be maintained. The roundness of the welding joint can not appear some small defects, otherwise, these are very easy to cause the operation failure and safety hidden trouble in the process of use.